90 Degrees Peel Fixture
90 Degrees Peel Fixture measures the adhesive strength to pull a tape off of a rigid surface using force at a 90 degree angle.
Showing 1–18 of 54 results

90 Degrees Peel Fixture measures the adhesive strength to pull a tape off of a rigid surface using force at a 90 degree angle.

AACC Spec Probe for measuring bread firmness and performing texture profile analysis (TPA). Fixture Base Table required.

Adhesive Tack Tester for measuring stickiness of pressure-sensitive adhesive materials such as tape. Rotary Base Table required.

Adjustable Vice Fixture for holding small samples for puncture test. Good for jelly beans, gum drops, etc. Rotary Base Table required.

Back Extrusion Cell for measuring consistency of applesauce, pudding yogurt and similar products. Rotary Base Table required,

Bi-Layer Shear Fixture measures shear strength by cutting a two-part tablet or capsule using a guillotine blade. Fixture Base Table Required.

Blister Pack Support Fixture is used to measure the force required to remove the tablet from its blister pack. Fixture Base Table requiered.

Capsule Loop Tensile Test Fixture is used to measure the force required to split one half of a hard gel capsule. Fixture Base Table required.

Cheese Extensibility Fixtures measure the extensibility of molten cheese sample to breaking point.

Circular Support Fixture provides support for round samples and retains any potential fluid expressed during the test. Fixture Base Table required

Compression Top Plate for applying uniform compression forces on samples up to 4×6 inches (10x15cm) Fixture Base Table required.

Confectionary Fixture for holding candies and similar products for penetration testing. Fixture Base Table required.

Craft Knife Adapter cuts cleanly into and through material with minimum deformation of the sample.

Cylindrical Probe TA-11 is used to measure the force vs. distance in mechanical springs. TA-11: included in TA-P-KIT2 or as a standalone part.

Dough Extensibility Fixture for holding sheet of raw dough or flat bread to measure the breaking point of the stretched sample. Fixture Base Table required.

Dough Stickiness Fixture is a standard test for measuring dough stickiness; important for processing raw dough. Fixture Base Table is required.

Dual Extrusion Cell for either forward or back extrusion of fruit puree, pudding yogurt or similar products. Fixture Base Table required.

Dual Grip Fixture for tensile testing of thin films or integrity of seals for packaging.